Filter
Top Products
Chapter 6 Setting Up Discovery and Device Management—CiscoWorks 1105/1130/1130-19
Adding Device Credentials to the WLSE
6-2
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Adding Device Credentials to the WLSE
This section provides procedures for entering the following required device
credentials on the WLSE:
• For all managed devices, you must enter SNMP credentials.
• For access points, the following additional credentials are required:
–
For IOS-based access points, you must enter Telnet or SSH credentials
and IOS HTTP port settings.
–
For non-IOS access points, you must enter HTTP credentials.
• For radio management, you must enter WLCCP credentials.
Enter SNMP Community Strings for All Managed Devices
SNMP community strings are used for discovery and for enabling WLSE features,
such as AP configuration jobs and radio management. The community string must
be set on each device, as described in Chapter 5, “Setting Up
Devices—CiscoWorks 1105/1130/1130-19.”. You can enter as many community
strings on the WLSE as necessary.
Note If you are importing devices, you do not need to enter their community
strings.The community strings will be imported along with the devices and will
be listed in WLSE Communities screen, in which you can modify and delete
strings as required. For more information, see Import Devices, page 6-11.
To configure community strings on the WLSE:
Step 1 Select Devices > Discover > Device Credentials > SNMP Communities.
Note This screen contains a default entry which can cover all devices, provided
device community strings are set to the default (public).