Filter
Top Products
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up Non-IOS Access Points and Bridges
5-2
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
After discovering and managing devices, you can use WLSE configuration
templates for configuration changes—See the User Guide for the CiscoWorks
Wireless LAN Solution Engine, Release 2.7.
Set Up Using the Web Interface
To use this method, you must first configure each access point or bridge for web
browsing.
Log in to the Web interface of the AP to be configured and set the following
parameters.
Table 5-1 Set Up Procedures for Non-IOS Access Points and Bridges
Tasks Procedure Notes
1. Enable Cisco
Discovery Protocol
(CDP).
1
1. In the Summary Status page, click Setup.
2. Under Services: Cisco Services, click
Cisco Discovery Protocol and select
Enabled.
3. Click Apply or OK.
Required for the WLSE to use
CDP to discover the device.
If you are not using CDP, add
all APs as seed devices or
import devices. See
Discovering Devices,
page 6-7.
2. Enable SNMP.
1. In the Summary Status page, click Setup.
2. Under Services, click SNMP.
3. Select Enabled.
4. (Optional) Enter a System Name, System
Location, and System Contact.
5. Click Apply or OK.
SNMP is required for the
WLSE to discover devices,
populate reports, transfer
configuration information to
devices, and upgrade device
firmware.
Setting the system name,
system contact, and system
location ensures that this
information is included in
device detail displays.