Filter
Top Products
56 CHAPTER 5: BASIC TELEPHONE OPERATION
phones enables Do Not Disturb, the feature applies to all phones—an
incoming call will not ring on any of the phones.
■ You can use the phone to dial outgoing calls.
■ If you enable Do Not Disturb while one or more calls are ringing, the
pending calls are sent to your call coverage point and Do Not Disturb
is enabled for all subsequent calls.
■ If you are a Hunt Group member and you enable Do Not Disturb,
personal (non-Hunt Group) calls go to your call coverage point.
However, Hunt Group calls always ring on a member’s phone,
regardless of the Do Not Disturb setting.
If your telephone is part of a bridged extension, see Do Not Disturb and
Bridged Line Calls for additional information.
To activate Do Not Disturb:
1 Press the Do Not Disturb Access button on the phone. The red light is lit
next to the Do Not Disturb button (Model 3102 only).
Your telephone is now in Do Not Disturb mode. The display panel shows
DND.
2 To disable Do Not Disturb mode, repeat step 1. The DND message
disappears from the display panel and the red light goes out.
Activating
Malicious Call Trace
The Malicious Call Trace feature enables you to notify the system if you
receive a harassing or abusive call. The calling party can be from either an
external or internal source.
Malicious Call Trace cannot be invoked when you are on a conference
call.
To activate malicious call tracing during a call, press Feature + 119.
The Display Panel shows
malicious call for 5 seconds.
The results of tracing a malicious call include the following actions:
■ Notification is sent to your network manager.
■ The log for the call includes a malicious call identifier.
■ For external malicious calls, the VCX system sends a message to the
authorities configured by your administrator to receive these reports.