Filter
Top Products
TL-WA7510N 5GHz 150Mbps Outdoor Wireless Access Point User Guide
91
Figure 5-19 PPPoE Advanced Settings
z MTU Size - The default MTU (Maximum Transmission Unit) size is 1480 bytes, which is
usually fine. For some ISPs, you need modify the MTU. This should not be done unless you
are sure it is necessary for your ISP.
z Service Name/AC Name - They should not be done unless you are sure it is necessary for
your ISP.
z ISP Specified IP Address - If you know that your ISP does not automatically transmit IP
address to the Device during login, click "Use the IP Address specified by ISP" checkbutton
and enter the IP address in dotted-decimal notation, which is provided by your ISP.
z Detect Online Interval - The default value is 0. You can input the value between 0 and 120.
The Device will detect Access Concentrator online every interval seconds. If the value is 0, it
means not detecting.
z Use the following DNS Servers - If your ISP specifies a DNS server IP address for you, click
the checkbox, and fill the Primary DNS and Secondary DNS blanks below. The Secondary
DNS is optional. Otherwise, the DNS servers will be assigned dynamically from ISP.
z Primary DNS - (Optional) Enter the DNS IP address in dotted-decimal notation provided by
your ISP.
z Secondary DNS - (Optional) Enter another DNS IP address in dotted-decimal notation
provided by your ISP.
)
Note:
The new advanced PPPoE parameters will not take effect until you dial-up again.
Click the Save button to save your settings.
Click the Back button when finished.