Filter
Top Products
TL-WA7510N 5GHz 150Mbps Outdoor Wireless Access Point User Guide
66
Figure 4-35 SNMP Settings
¾ SNMP Agent - Choose Enable to open this function if you want to have remote control
through SNMPv1/v2 agent with MIB-II. Choose Disable to close this function.
¾ SysContact - The textual identification of the contact person for this managed node.
¾ SysName - An administratively-assigned name for this managed node.
¾ SysLocation - The physical location of this node.
)
Note:
Specifying one of these values via the Device's Web-Based Utility makes the corresponding object
read-only. If there isn't such a config setting, then the write request will succeed (assuming
suitable access control settings), but the new value would be forgotten the next time the agent was
restarted.
¾ Get Community - Enter the community name that allows Read-Only access to the Device's
SNMP information. The community name can be considered a group password. The default
setting is public.
¾ Get Source - Defines the IP address or subnet for management systems that can read
information from this 'get' community device.
¾ Set Community - Enter the community name that allows Read/Write access to the Device's
SNMP information. The community name can be considered a group password. The default
setting is private.
¾ Set Source - Defines the IP address or subnet for management systems that can control this
'set' community device.