Filter
Top Products
TL-WA7510N 5GHz 150Mbps Outdoor Wireless Access Point User Guide
23
z Wireless Radio- The wireless radio of the AP can be enabled or disabled to allow or deny
wireless stations to access. If enabled, the wireless stations will be able to access the AP;
otherwise, wireless stations will not be able to access the AP.
z MAC of AP- Enter the MAC address of AP that you want to access. If you select the radio
button before MAC of AP, the AP client will connect to AP according to MAC address.
z Region- Select your region from the pull-down list. This field specifies the region where the
wireless function of the AP can be used. It may be illegal to use the wireless function of the
AP in a region other than one of those specified in this filed. If your country or region is not
listed, please contact your local government agency for assistance.
When you select your local region from the pull-down list, click the Save button, then the
Note Dialog appears. Click OK.
Note Dialog
z Max Tx Rate- You can limit the maximum tx rate of the AP through this field.
You can select one of the following security options:
z Disable Security- The wireless security function can be enabled or disabled. If disabled, the
wireless stations will be able to connect the AP without encryption. It is recommended
strongly that you choose one of the following options to enable security.
z WPA-PSK/WPA2-PSK- Select WPA based on pre-shared passphrase.
z PSK Password- You can enter ASCII or Hexadecimal characters.
For ASCII, the length should be between 8 and 63 characters.
For Hexadecimal, the length should be between 8 and 64 characters.
Please note that the key is case sensitive.
z Not Change- If you chose this option, wireless security configuration will not change.
5) Universal Repeater
In Universal Repeater mode, the AP with WDS disabled will relay data to an associated root AP.
AP function is enabled meanwhile. The wireless repeater relays signal between its stations and
the root AP for greater wireless range. Please input the MAC address of root AP in the field "MAC
of AP".