Filter
Top Products
IPedge
Feature Operations
56 TOSHIBA
IPedge UG 06/11
Executive Override Executive Override enables you to enter an established conversation. Your
telephone can also be programmed to block Executive Override from other
telephones.
To perform Executive Override
• After reaching a busy station, press 3
Or, if you have an LCD telephone, use the OVRD Soft Key. You enter
a conference with the busy station and the party to whom he was
talking. The called parties may hear an optional tone signal prior to
your entering the conversation.
Your LCD displays EXEC OVR DENY if the station you called denies
Executive Override. If you do not have Override privileges, you will
camp on.
Destination Restriction/
Traveling Class Override
Enables a station user to override the Destination Restriction or Traveling
Class of a particular telephone by entering a pre-determined account code.
To use Destination Restriction or Traveling Class Override
1. Press #471. A Confirmation tone plays and the LCD shows “Enter OVR
Code.”
2. Enter the trunk access code or LCR access code.
3. Dial the external telephone number.
Class of Service Override By dialing a Class of Service (COS) Override code, a user can change a
station’s set of privileges to one associated with the override code. When the
call is terminated and another is attempted from the same station, the original
COS is applied. This allows selected users to override restrictions that are
placed on any telephone in the system.
To perform Class of Service Override
1. Access a Primary or Phantom DN. You hear a dial tone and the LED
flashes at the in-use rate.
2. Press #471. Dial tone stops. Your LCD prompts you to enter a code.
3. Enter the COS Override Code (four digits). You hear a dial tone.
4. Dial a telephone number.
Note: For security reasons, the override codes are only available on a
selected basis. See your System Administrator.
Privacy Override This feature enables you to enter an established call on a line you share with
another telephone. Up to two station users can enter an existing Central
Office (CO) line-to-station call (i.e., up to three stations can be connected to a
CO line). You can also use this feature if the station that is already connected
to the CO line is in the Privacy Release mode.
Station users with Privacy Release can allow stations with the shared
button appearance to enter their conversations, even if the station entering
the conversation is not programmed for Privacy Override.