Teledyne C-2000 Telephone User Manual


 
59
(Rev. 8/04)
®
E4. Setting the HF Radio Option Label
(This is a System Function)
The HF Radio Label is accessible and may be modied by the
handset user.
Start Maintenance Session. Press 6(AIU), Press 2 (HF Radio),
and then press + (More).
The stored label for the HF Radio will be displayed.
To receive on-screen instructions for entering the 8-character alpha-
numeric label, press 0(Help).
There are four different character lists: punctuation characters, upper
case letters, lower case letters and digits. By pressing 5you may
switch between the various lists.
To move up a list (A-Z, a-z, 0-9) press 6.To move down a list
(Z-A, z-a, 9-0) press 4.
To move the cursor to the next label space press *(Cursor). If you
need to return to a previous label space continue to press * (Cursor).
To accept the label and return to the main menu, press #(OK).
F. Set-Up for the Cell Phone
Interface (CPI)
F1. Analog Interface Configuration
(This is a System Function)
Start a Maintenance Session. Press 6(AIU). Press
3(Satcom / GroundCell) for desired setting.
Selecting GroundCell will display GroundCell on
the Servicesscreen and allow this communication
link to be selected on the Main and Holdmenus.
F2. Auto Link Switch Configuration
(This is a System Function)
Start a Maintenance Session. Press +(More) and
then 4(Link). Press 3 (Enable/Disable Aircraft
Auto Link Switch) for desired setting.
Selecting the Enableoption will cause a call setup
attempt to automatically occur over the alternate link
if the current link (see Section IV, E) is not available.
After the call is set up, the link in use is indicated on
the digital handset display.
Congure
GroundCell
|Satcom/
GroundCell
Select >3
Go Back >#
Handset
Default
Link:
Air-Gnd >1
Satcom >2
To Disable
Aircraft
Auto Link
Switch >3
Go Back >#