Filter
Top Products
®
41
(Rev. 8/04)
F. Conference Calls Using
All Available Links
If a call is in progress, a conference member can be
added using the same or another communication link.
Place the call on hold by pressing “+” (Put Call on
Hold). Press “6” to rotate through the available links
(Satcom, GndCell or Air-Gnd). Press “1” (Voice).
Dial the telephone number. After the called party
answers, press “+” (Add Call to Conference).
NOTE: To switch to a TDD call you may press “5” whether or
not it is displayed.
G. Speed Dialing
User-stored speed dial numbers apply to whatever link is currently
selected; Speed Dial numbers only apply to the Air-Ground link.
H. SATCOM System
Management Commands
The user can send these commands to configure a Satellite Data Unit
(SDU) by selecting a SATCOM Voice call from the Main menu and
then entering the dialed digits (which always start with “**” for
Honeywell SATCOM commands or “*” for Collins SATCOM com-
mands).
NOTE 1: Use the “6” key to select the SATCOM link, and then press “1” (Voice)
followed by the command.
NOTE 2: When the system is configured for GroundCell and /or Digital
SATCOM, the dialed digits for these commands are sent to the SDU
via AIU channel #1.
I. Short SATCOM Telephone Numbers
The user can dial a short (2-6 digits, not starting with a “0”) SATCOM
telephone number by selecting a SATCOM call from the Main menu
and then entering the dialed digits.
Conf:
Voice — —>1
Inplane —>2
Switch to
Fax — —>3
Modem —>4
TDD — —>5
Satcom —>6
2nd Call —>8
Go Back —>#
Air-Ground
Hold Menu