Filter
Top Products
52
(Rev. 8/04)
®
B20. 9600 bps/4800 bps Modem Data Calls
Software version 4.0A (or later) allows for two simultaneous single
channel 4800 bps Air-Ground modem calls, or a single dual channel
9600 bps Air-Ground modem call.
To set up the station default modem call baud rate, start a Maintenance
Session. Press “+” (More) and then “5” (Modem). Press “1” (4800
bps) or “2” (9600 bps) for desired setting.
B21. Modem Data Call Handoffs
(This is a System Function)
Software version 4.0A (or later) allows for 9600 bps/4800 bps data
call handoffs.
To enable data call handoffs, start a Maintenance Session, press “+”
(More) and then “5” (Modem). Press “3” to enable 4800 bps and/or
“4” to enable 9600 bps.
B22. Receiving Calls via a CDBR-2 PC Station
(This is a System Function)
Software version 4.0B (or later) allows for a CDBR-2 PC station to
receive uplink Ground-Air calls. The CDBR-2 station must be strapped
for PC and can be configured to receive Voice, Fax or TDD calls from
the ground through Remote Programming.
To configure, start a Remote Programming Maintenance Session
(Section VI, B18), press “+” (More) and then press “1” (Station Setup)
to view station settings. Uplink calls can be then configured by choos-
ing “3” for Voice, “4” for Fax (Factory Default), or “5” for TDD.
NOTE: For calls originating in the aircraft, the following dialing prefixes are valid
for a CDBR-2 PC station: “1” (Voice), “2” (Inplane), “3” (Fax), “4”
(Modem), “5” (TDD), and “
*
” (Speed Dial).