Filter
Top Products
®
16
(Rev. 8/04)
C7. Two Calls On One Handset
Should you wish to converse privately with two dif-
ferent parties at the same time, two independent calls
can be placed on the same handset. While conversing
with the first party, place the call on hold by pressing
“+.” Press “8” (2nd Call) to enter second call set-up
mode. Call the second party the same way you called
the first party.
You may switch between the two calls by pressing
“+” (Put Call on Hold). This will place your current
call on hold and connect you to the other party. To
end one of the calls, press “End Call” while connected to the party
you wish to disconnect. You will immediately be connected to the
other party. To end both calls at once, place the handset on-hook,
or press “End Call” twice.
C8. Conference Calls
Conference calls may be set up between any number of users on-board
the aircraft and one or two parties on the ground. Multiple ground
parties may also be conferenced using Airfone’s conferencing service.
a. Setting Up a Conference Call. Call the first conference member
and place the call on hold by pressing “+.”
To add a conference member on the ground, press “1” (Voice)
and enter the telephone number.
To add a conference member on-board the aircraft, press “2”
(Inplane) and press the inplane number (see Section II, D).
To connect the new party to the conference, press “+” (Add Call
to Conference). If you do not wish to add the called party to the
conference, press “End Call.” The current call is disconnected
and you are re-connected to the conference.
If you wish to add additional members, press “+” to
place the conference on hold and proceed as previous-
ly described. While the conference is on hold, you
will be temporarily disconnected from the conference.
The rest of the parties are still conferenced together.
NOTE: A conference member can be added using an alternate
communication link (See Section IV, F).
Air-Ground
Call:
(_____)
____-______
Put Call
On Hold —>+
Conf:
Voice — —>1
Inplane —>2
Switch to
Fax — —>3
Modem —>4
TDD — —>5
2nd Call —>8
Go Back —>#
Hold Menu