Filter
Top Products
57
(Rev. 8/04)
®
D6. Station Alerting for Aircraft Terminal ID Number
In a system with several digital handsets the user may wish to have
certain handsets disabled from ringing for uplink calls to the aircraft
Terminal ID number. Calls to the station Terminal ID number are unaf-
fected by this option. Start a Maintenance Session. Press “4” (Phone #)
and then press “3” (Satcom) followed by “+” (More). Press “1” (yes)
or “2” (no) for desired setting. This step also affects the Call Alerter
Switch (CAS) in the same manner.
D7. Aero I/H + Dialing
(This is a system function)
When this feature is enabled, the MagnaStar software will automatical-
ly replace the “00” dialed number prefix which is sent to the Satellite
Data Unit (SDU) with a “01” or “02” for fax or modem calls respec-
tively.
NOTE: This applies to all of the dialing formats listed in Section IV, B.
Start a Maintenance Session. Press “+” (More) and then press “3”
(Dialing plan) to get to the dialing plan configuration screen. Press “3”
to enable/disable this feature.
D8. Aero H+ Higher Rate Fax Dialing
(This is a system function)
Software version 4.0B allows for the selection of Aero-H SATCOM
service, instead of Aero-I SATCOM service for Fax calls. If both serv-
ices are available (Aero-H+), the SDU defaults to Aero-I. However,
Aero-I supports 2400 bps Fax calls while Aero-H supports 4800 bps
Fax calls. Enabling the 4800 bps feature should only be enabled for
Aero-H+ SATCOM installations. If enabled for Aero-H or Aero-I
installations, the SDU will reject the Fax call setup.
When this feature is enabled, the MagnaStar software will automatical-
ly replace the “00” dialed number prefix which is sent to the Satellite
Data Unit (SDU) with a “96” or “02” for fax or modem calls respec-
tively.
NOTE: This applies to all of the dialing formats listed in section IV, B.
After enabling the Aero-I/H+ Dialing (Section VI, D7), press “+” (More)
and then press “1” to enable (4800 bps)/disable (2400 bps) this feature.