50
(Rev. 8/04)
®
B15. Configuring the Auxiliary Call Alert Function
In addition to the handset ringer a Call Alerter Switch (CAS) is avail-
able to control cabin chimes, indicator lights, or other devices used to
indicate receipt of an aircall. The CAS can control up to ten independ-
ent devices and is configured through the “Setup” option screens.
Start a Maintenance Session at the handset to be configured. Press “+”
(More) three times to get to the Auxiliary Call Alerter configuration
screen. Select the device (0-9) to be activated by this handset by press-
ing the corresponding key on the keypad; the selected device number
will be highlighted. During the Maintenance Session selecting the Call
Alerter device activates that device, thus providing confirmation of
proper system wiring and programming.
NOTE: If desired, the handset may be configured to activate multiple devices by
pressing additional numbers. Also, multiple handsets can be configured
to activate a single device.
B16. Configuring the Auxiliary Call Alerting Cadence Function
(This is a System Function)
Each device connected to the CAS may be configured to either a
cadence mode (2 seconds on/4 seconds off) or continuous (On) mode
when activated.
Start a Maintenance Session. Press “+” (More) three times to get to the
Auxiliary Call Alerter screen and then press “*” (for Cadence) to get to
the Auxiliary Call Alerter Cadence Selection configuration screen.
Select the devices (0-9) to either be cadenced or steady. Highlighted
devices are cadenced. Non-highlighted devices are steady.
B17. Default Dialing Plan
(This is a System Function)
The Dialing Plan selects the destination country’s “domestic” dialing
plan.
Start a Maintenance Session. Press “+” (More) and then press “3”
(Dialing Plan) to get to the dialing plan configuration screen. Press
“1” to select the “US/Canada” dialing plan as the default dialing plan.
Press “2” to select the “Mexico” dialing plan as the default dialing
plan. The current default dialing plan is highlighted.