Filter
Top Products
C1. Placing a Voice Call
Domestic
Place the handset off-hook. Choose “1” (Voice), then
enter “1” + Area Code + Number. The number will be
displayed for approximately one second before it is
sent. The digit “1” before the area code is optional
and need not be entered.
International
Place the handset off-hook. Choose “1” (Voice), then
enter “011” + Country Code + City Code + Number.
Because international telephone numbers vary by the
number of digits, pressing “+” (OK) after the number
has been entered will send it immediately. If “+”
(OK) is not pressed, there will be a ten (10) second
delay before it is sent.
Once the number has been sent, “Acquiring Air-
Ground Channel” should appear on the “Acquiring
& Waiting” menu. If there is a delay, one of several
messages will be displayed giving an explanation
(refer to Section II, B2).
NOTE: If you make a mistake when entering a number, press “*” to clear the dig-
its and dial the number again.
To end call, place the handset on-hook or press “End Call.”
NOTE: The following dialing formats will be accepted by the MagnaStar for all
communication links:
Direct Billing
Area code + Number
“1” + Area code + Number
“00” + Country Code + City Code + Number
“011” + Country Code + City Code + Number
Credit Billing
“0” + Area code + Number
“000” + Country Code + City Code + Number
“01” + Country Code + City Code + Number.
12
(Rev. 8/04)
®
Enter
Telephone
Number
(___)
____-_______
Air-Ground
Redial —>+
Help — —>#
Spd Dial —>*
Acquiring
Air-Ground
Channel
Waiting on
next
available
Air-Ground
channel