Teledyne C-2000 Telephone User Manual


 
®
14
(Rev. 8/04)
C3. Placing a Call with the Cockpit Headset Interface Panel
(C.H.I.P.)
The C.H.I.P is intended to allow the cockpit crew to place or receive
phone calls through their existing audio control panel. It may also be
mounted in the cabin and used with a headset and mic as an alternative
to a handset. The C.H.I.P. functions like a WH-10 analog phone with
the addition of a few pushbuttons.
The Hook Switch pushbutton is used to take the headset On-Hook
and Off-Hook.
The Flash Hook pushbutton has two functions. A short ash places
a call on hold and allows the user to conference another call. A long
ash will end your call and back you up to the main menu to allow
another call.
The Volume pushbuttons adjust the headset volume.
NOTE: For programming see Section VI, B18 (CDBR-2 and Remote Set Up).
C4. Placing a Voice Call Using a Credit Card
Normally all calls made with the MagnaStar C-2000 are automatically
charged to the aircrafts billing account. If desired, a call may be
charged to a personal credit card instead. Calls made using a personal
credit card will be billed at commercial rates.
Place the handset off-hook. Choose 1(Voice), then
enter 0 + Area Code + Number. At the bongtone,
slide your credit card through the handset slot with
the magnetic stripe facing inward.
For international calls, choose 1(Voice), then enter
01+ Country Code + City Code + Number ++
(OK) key. A bongtone and the display screen will
prompt you to slide your credit card through the
handset slot.
NOTE 1: If you make a mistake when entering either the phone number or any
additional information, press “*” to clear the entered digits and re-enter
the information.
NOTE 2: Refer to the Credit Billing dialing formats listed in Section II, C1.
To end a call, press End Calland place the handset on-hook.
Pass
Credit Card
Thru Slot
on Right >2
Keypad
Entry >+
Exit #