Teledyne C-2000 Telephone User Manual


 
F4. Link selection dialing prefixes for individual calls
#61# Selects Air-Ground (disables Auto Link Switch)
#62# Selects GroundCell (disables Auto Link Switch)
#63# Selects SATCOM (disables Auto Link Switch)
#612# Selects Air-Ground then GroundCell (SATCOM not included
in the rotation). Used with Genesys Airshow.
NOTE 1: These prefixes override the station default link (see Section VI, D1).
NOTE 2: Both Baud Rate and Link Selection prefixes can be utilized for the same
call (order sequence does not matter)
NOTE 3: The Link Selection prefixes can be used for all call types (i.e. Voice, Fax,
Modem and TDD).
G. Telecommunication Device for
the Deaf (TDD)
Place the handset off-hook. If your TDD has a RJ-11 cord, connect the
cord into the RJ-11 jack on the handset. Press 5 (TDD) and dial the
telephone number from either the handset or the TDD unit.
NOTE 1: For a ground-to-air TDD call, a delay greater than 20 seconds is needed
after the dialed number. This is necessary to bypass the voice prompts,
otherwise the ground modem will disconnect the call.
NOTE 2: It is not necessary to press “5” (TDD) if this handset has been config-
ured as a TDD station. To set the station mode refer to Section VI, B5.
If you want the TDD unit to be acoustically coupled, make certain that
no RJ-11 cord is connected prior to dialing the telephone number from
the handset. When prompted, press + (To Use TDD Acoustic
Coupler) to indicate your desire to use the TDD acoustic coupler.
Press End Call to terminate the call. The connection will be termi-
nated automatically if the ground party hangs up rst.
27
(Rev. 8/04)
®