Filter
Top Products
Answering System
Preparation
85
Telephone System Useful Information
Cancelling Registration/Re-registration
If the Following Appear on Your Display...
The following will be displayed on the handset when the unit needs your attention.
If you have not cancelled the handset’s registration at the previous base unit
(p. 83), the handset number remains in that base unit’s memory. To erase the
handset number from the previous base unit, see the base unit’s Operating
Instructions. For the KX-TG5240AL base unit: (1) Press and hold [LOCATOR/
INTERCOM/TRANSFER] for 3 seconds, and (2) Press and hold the handset
number [1]
( ) to
[4]
()
that you do not want for 5 seconds. A long beep
sounds, then the handset number is erased.
Display message Cause & Remedy
Recharge battery
• The battery needs to be charged. Recharge the
battery (p. 14).
Charge for 6 HRS
• The battery has been discharged. The handset will
not work. Fully charge the battery (p. 14).
No link to base.
Move closer to
base and try
again.
• The handset has lost communication with the base
unit. Walk closer to the base unit, and try again.
• Confirm the base unit’s AC adaptor is plugged in.
• Raise the base unit antennas.
• The handset’s registration may have been cancelled.
Re-register the handset(p. 83, 84).
Please lift up
and try again.
• A handset button was pressed while the handset was
on the base unit (or the charger, for accessory
handset users, p. 3). Lift the handset and press the
button again.
Busy
• The called base unit or handset is in use.
• Privacy mode is on for the call you tried to join
(p. 58).
• The handset you tried to send phone book items to is
in use.
• The handset you are calling is too far from the base
unit.
Invalid
• The called handset has not been registered to the
base unit.
• You selected your own extension number.
TG5240AL.fm Page 85 Friday, June 11, 2004 5:22 PM