Filter
Top Products
Useful InformationAnswering SystemTelephone System
19
Programmable Settings
Preparation
Base unit ringer volume
Make sure the base unit is not being used.
To set the ringer volume to high (preset), medium, or low,
press
[
d
]
or
[
B
]
.
• To increase volume, press [B]. To decrease volume, press [d]
.
• To stop ringing, press [STOP].
To turn the ringer off, press and hold [d] until 2 beeps sound.
• “ ” is displayed.
To turn the ringer on, press [d] or [B].
• The base unit will ring at the low level.
• You can adjust the ringer volume while an outside call is ringing.
Press
[d] or [B] while the base unit is ringing.
To turn the ringer off, press and hold [d] until 2 beeps sound. “ ” is displayed.
Ringer Tone
You can set the handset and base unit ringers to use one of 7 ringer patterns for
outside calls. “Tone 1” to “Tone 3” are bell ringer patterns. “Melody 1” to “Melody 4”
are melody patterns. The factory preset is “Tone 1”.
• You cannot change the ringer tone for intercom calls.
• If you select one of the melody ringer patterns, the ringer will continue to sound for
several seconds if:
— the caller hangs up before you answer the call, or
— another person ans
wers the call using another phone connected on the same line.
Handset ringer tone
1 Press [MENU].
2 Press the soft key ( ) at “Ringer
setting”.
3 Scroll to “Ringer tone” by pressing [d] or
[B], then press the soft key ( ).
4 Select the desired ringer tone by pressing
[d] or [B].
• The handset will ring and the ringer tone will
change. If the ringer volume has been turned off,
the handset will not ring (p. 18).
• You can also select the ringer tone by pressing
[1] to [7].
5 Press the soft key ( ), then press [OFF].
Base Unit
RINGER
OFF
RINGER
OFF
Handset
SELECT
Ringer setting
SELECT
Ringer tone
Ringer tone
1:Tone 1
SAVE
TG5240AL.fm Page 19 Friday, June 11, 2004 5:22 PM