Nortel Networks PO937240 02 Wireless Office Headset User Manual


 
86 Chapter 9 Customize your telephone
P0937240 02
Default button assignments
During Startup, the installer chooses one of the available templates. Default features are assigned
automatically to the programmable buttons on telephones in the system, and vary with the template
and the telephone. The default features appear in the following tables in this chapter.
Rules of default button assignment
Line and Intercom buttons assigned by default templates can be changed in programming.
Handsfree/Mute and answer button features are not assigned by default. If these features are
defined, however, they are automatically assigned to specific buttons, as described on this and the
following page. None of these buttons are available on the T7100 telephones. Refer to T7316 and
T7208 telephone button defaults on page 88.
The T7316 and T7208 telephones can have up to eight Intercom buttons. They appear above the
Handsfree button at the bottom right-hand corner on your telephone.
Each telephone can have up to four answer buttons. They appear above Intercom buttons in the
right column and continue up from the bottom in the left column, replacing the features on those
buttons.
External line buttons appear in ascending line order, starting at the top button in the left column
(the top button on the T7208 telephone). If more than eight external lines are assigned to a T7316
telephone, or more than 12 to a M7324(N) telephone, assignment continues down the buttons on
the right column, erasing the feature codes on those buttons. Line buttons have priority over feature
access buttons except for the Handsfree, Intercom, or answer buttons.
Press the button you want to check. Press or
EXIT
when
finished.
Enter the number you want to program and press . To erase
the button, press .
Enter the number you want to program and press
OK
. To erase
the button, just press or
OK
.
For other displays, see Appendix B, Common display prompts and error messages, on
page 137.
Press a button
EXIT
Program and HOLD
Program and OK
QUIT OK