Filter
Top Products
84 Chapter 9 Customize your telephone
P0937240 02
Change the type of ring
You can select one of four different rings for your telephone. This selection makes it easier to
identify your telephone in an open office.
1 Press ≤•fl.
2 Press ⁄, ¤, ‹, ›, or
NEXT
.
You hear the selected ring for two seconds.
3 Repeat until you hear the ring you like, then press ≥ or
OK
.
Adjust the Ring volume
1 Press ≤•°‚.
The telephone rings.
2 Press √
to adjust the volume: left end to decrease, and right end to increase.
Button Inquiry
You can check the function of any line, intercom, or programmed button on your Business
Communications Manager telephone by pressing
≤•‚ and a button. On the T7100
telephone, Button Inquiry shows your internal number followed by the function assigned to your
single memory button.
The display shows the number and name of the line. Press
SHOW
to view the redirection status of the line.
Press £ or press
VIEWâ
or
áVIEW
to view a number that is too
long to fit on the display. Press ≥ or
OK
when done.
The display shows the directory number of the telephone, and
the assigned name. Press
NEXT
to see the first line assigned to
ring at the intercom button.
The name of the feature assigned to a button appears on the
display when you press the button. Press £ or
SHOW
for
additional information.
Press the button you want to check. Press ≤ or
EXIT
when
finished.
For other displays, see Appendix B, “Common display prompts and error messages,” on
page 137.
061 <LINENAME>
SHOW OK
123456789012345...
VIEWâOK
221 <SETNAME>
NEXT VIEWâ
<Feature name>
SHOW OK
Press a button
EXIT