Filter
Top Products
82
Appendix B: WLAN Application Gateway 2246
• for the WLAN Application Gateway 2246, a maximum distance of 325 feet (100 meters) from
the Ethernet switch
Mounting the WLAN Application Gateway 2246
The WLAN Application Gateway 2246 is physically connected to the Ethernet switch and can be
placed in any convenient location within 325 feet (100 m) of the switch.
The WLAN Application Gateway 2246 can be mounted either vertically or horizontally.
The rack-mount kit is designed for mounting the WLAN Application Gateway 2246 in a standard
19-inch rack and contains the following equipment:
• Mounting plates – two for each WLAN Application Gateway 2246 to be mounted.
• Screws – four rack-mount screws for each WLAN Application Gateway 2246 to be mounted.
Wall-mounting the WLAN Application Gateway 2246
1 Use a 1/8-inch drill bit to drill four pilot holes, on 1.84-by-12.1 inch centers (approximately
equivalent to 1-13/16 inch by 12-1/8 inch).
2 Insert the #8 x 3/4-inch screws in the pilot holes and tighten, leaving a
1/8 to 1/4-inch gap from the wall.
3 Slide the WLAN Application Gateway 2246 over the screws until it drops into place in the
keyhole openings of the flange.
4 Tighten screws fully.
Rack-mounting the WLAN Application Gateway 2246
1 Remove the corner screws from the WLAN Application Gateway 2246.
2 Screw the U-shaped end (round screw holes) of the two mounting plates to the WLAN
Application Gateway 2246.
3 Screw the other end of the two mounting plates (oblong screw holes) to the rack.
4 Repeat steps 1-3 for each additional WLAN Application Gateway 2246. The mounting plate is
designed to provide the correct minimum spacing between units. When mounting multiple
units, stack the units in the rack as closely as possible.
Connecting to the LAN
Use an RJ-45 cable to connect the NETWORK port on the WLAN Application Gateway 2246 to
the connecting port on the Ethernet switch.