Filter
Top Products
43
WLAN IP Telephony Manager 2245 installation
Rack-mounting the WLAN IP Telephony Manager 2245
1 Remove the corner screws from the WLAN IP Telephony Manager 2245.
2 Screw the U-shaped end (round screw holes) of the two mounting plates to the WLAN IP
Telephony Manager 2245.
3 Screw the other end of the two mounting plates (oblong screw holes) to the rack.
4 Repeat steps 1-3 for each additional WLAN IP Telephony Manager 2245. The mounting plate
is designed to provide the correct minimum spacing between units. When mounting multiple
units, stack the units in the rack as closely as possible.
Connecting to the LAN
Use an RJ-45 cable to connect the NETWORK port on the WLAN IP Telephony Manager 2245
to the connecting port on the Ethernet switch.
Connecting the power
1 Connect the power plug from the AC adapter to the jack labeled PWR on the WLAN IP
Telephony Manager 2245.
2 Plug the AC adapter into a standard AC outlet (that is, one that is compliant with local power
supply) to supply power to the WLAN IP Telephony Manager 2245.
The system cycles through diagnostic testing and the LEDs blink for approximately one
minute.
3 When the system is ready for use, verify the following:
•The ERROR LED is off.
• Status 1 is blinking.
Removing a WLAN IP Telephony Manager 2245
1 Disconnect the power cables and LAN cables from the WLAN IP Telephony Manager 2245.
2 Remove the failed device from the wall or rack mount.
Warning: Use only the provided Class II AC adapter with output 24V DC, 1A.