Filter
Top Products
70
WLAN Handsets 2210/2211 configuration
Programming the WLAN Handsets 2210/2211
The Line keys 1-6 on the WLAN Handsets 2210/2211 are programmable by the end user. These
Line keys can be programmed in the wireless handset in the same manner they are programmed on
the IP Phone 2004.
Follow the steps in “Programming the Line keys” to program keys on the wireless handset.
Programming the Line keys
There are three menus available for the Line keys. The menu available is dependent on the state of
the WLAN Handset 2210/2211. Two menus are programmed using the BCM and one is
user-defined. The IP features list is programmed using the BCM and is available to all handsets.
For information on user-defined programming of the Line keys and using the WLAN handset
features, refer to the Nortel Networks WLAN Handset 2210/2211 User Guide.
Configuring the idle state display
When the set is in the idle state, it displays “Ext.----”. Nortel Networks recommends that you
configure this display to show the Directory Number (DN) of the handset. To configure this
display, place the set in the idle state:
1 Press the FCN key.
2 Select Extension from the menu using the up and down arrow buttons on the left of the set.
3 Press OK.
A screen appears.
4 Enter your the DN under New Ext: on this screen.