Filter
Top Products
84 Issue 1 April 1997
Recorded Announcements
3. Press and record after the tone. Hang up, press , or press the
switchhook when finished.
4. Dial the extension number of the announcement you just recorded.
5. Listen to the recording. If you need to re-record the message, repeat
Steps 1 through 3.
6. If the message is satisfactory, hang up and repeat Steps 1 through 3 to
record the rest of the messages.
The integrated announcements circuit pack has the following recording time
limit based on the sampling rate used:
■ 8 minutes, 32 seconds at 16 KHz
■ 4 minutes, 16 seconds at 32 KHz
■ 2 minutes, 8 seconds at 64 KHz.
For the speech synthesizer circuit pack (TN725B), do the following:
1. At a voice terminal, dial the Verify Wakeup Announcements feature
access code _____.
2. Dial 1 or 2.
■ Listen to the announcement. There may be a short delay before
you hear the announcement.
3. If the wakeup announcement is absent, distorted, inaudible, or defective
in any way, follow local procedures to correct the problem.
Administration 0
change feature-access-codes
■ Use this form to add the Announcement and Verify Wakeup Announce-
ment feature access codes.
1 Drop