Filter
Top Products
TRANSCEIVER PROGRAMMING
3-15
November 1999
Part No. 001-7780-500
3.6.3 SMARTNET/SMARTZONE SYSTEM
OTHER ID’S SCREEN
The SMARTNET/SmartZone Other ID’s screen
is shown above, and it programs the following
parameters.
Individual ID
- Uniquely identifies the radio on a par-
ticular system. Each radio must have a different Unit
ID. Valid Unit IDs are from 1-49152.
Connect Tone
- The tone expected by the controller
on the traffic channel to verify that a subscriber trans-
mission is occurring. This tone should be set the
same as it is in the controller.
3.6.4 SMARTNET/SMARTZONE SYSTEM
PHONE INTERCONNECT SCREEN
The SMARTNET/SmartZone Phone Intercon-
nect screen is shown above, and the parameters it
programs are as follows:
Phone Interconnect
Refer to Section 2.5.6 for more information on
telephone calls.
Disabled
- Telephone calls cannot be placed or
received.
Answer Only
- Telephone calls can be received but
not placed.
List Only
- Telephone calls can be placed and
received, and numbers can be recalled from memory
only.
Unlimited
- Telephone calls can be placed and
received, and numbers can be recalled from memory
or dialed using the front panel keypad (full keypad
15-key models only).
Private Call
Same as above, but for private (unit-to-unit) calls.
Refer to Sections 2.5.4 and 2.5.5 for more information.
Private Call II
Programs either standard (Private Conversation
II™) or enhanced (Enhanced Private Conversation™)
private calls as follows:
Standard
- The user does not receive any feedback
when the called radio is not active in the system.
Only a “No Answer” is received if the called radio
does not answer.
Enhanced
- When a call is placed, the system tells the
user if the called radio is currently active in the sys-
tem and within range. Thecalling radio displays “NO
ACK” if the called radio is not active in the system
and “NO ANSWR” if it is active but does not answer.
Phone DTMF Timing
Initial Delay
- Delay from 50-500 milliseconds from
when a traffic channel is granted for phone intercon-
nect to the start of the dialing out of the phone
number.
Digit Duration
- Duration from 50-500 milliseconds
of each phone number digit.
Inter-Digit Delay
- Delay from 50-500 milliseconds
between each digit of a phone number.