Filter
Top Products
TRANSCEIVER OPERATION
2-21
November 1999
Part No. 001-7780-500
Six Beeps
• The paged radio received the page and acknowl-
edged it (Section 2.5.7).
• The message that was sent has been received and
acknowledged (Section 2.5.8).
• The status condition that was sent has been received
and acknowledged (Section 2.5.9).
Two Beeps
• The emergency alarm condition was acknowledged
(Section 2.5.10).
Gurgle-Like Tone
• Dynamic regrouping has occurred (Section 2.5.13).
• Dynamic regrouping has occurred but the
regrouping channel is not selected (Section 2.5.13).
Four Low Tones (Busy Signal)
• The radio system is busy or a busy condition exists
when making a telephone call.
Four Alternating High and Low Tones
• A channel is available after a busy condition
occurred (SMARTNET/SmartZone only).
2.7 KEYPAD PROGRAMMING
2.7.1 INTRODUCTION
NOTE: Keypad programming is available with full
keypad (15-key) models only.
Keypad programming is available if the Keypad
Programming option switch is programmed. It is then
selected by simply pressing this switch (no password
is required). Keypad programming allows conven-
tional channel parameters such as the transmit and
receive frequency and Call Guard squelch code to be
changed. In addition, it allows several conventional
mode timers to be changed. It cannot be used to repro-
gram disabled channels or SMARTNET/SmartZone
channels.
2.7.2 MENU DESCRIPTION
A menu is used to select parameters to be
changed in the keypad programming mode. When the
Keypad Programming mode is selected by pressing the
option switch, the “
P
”and“
G
” icons are displayed
(see Figure 2-3) along with the first menu parameter
“ZONE CHG”.
The four main menu parameters are listed below,
and descriptions are located in the indicated section.
Press the and keys to display the desired
parameter and then press the
ENT
key to select it.
Pressing the
CLR
key in any of the four main menus
exits the keypad programming mode. Pressing it in the
other menus returns to the previous menu. A flowchart
showing the keypad programming mode menu struc-
ture is located in Figure 2-4.
• ZONE CHG (2.7.3)
• CHAN CHG (2.7.4)
• SYS PRM (2.7.5)
• CHAN PRM (2.7.6)
Figure 2-4 Keypad Programming Menu
Flowchart
2.7.3 ZONE CHANGE PARAMETER
The “ZONE CHG” menu parameter selects the
zone containing the conventional channel to be repro-
grammed. It does not change the zone selected for
normal operation. Enter the zone number or scroll
through the programmed zones by pressing the
and keys. When the desired zone is displayed,
select it by pressing the
ENT
key.
Zone
Channel
Change
Change
System
Parameters
Channel
Parameters
Select
Zone
Select
Channel
Scan Hold Timer
Time-Out Timer
Penalty Timer
Conver. Timer
Rx Freq
Tx Freq
Rx CG Code
Tx CG Code
Tx Power
TOT On-Off