Filter
Top Products
3-8 FAXING
Real-time transmission (non-memory transmission)
Your machine will dial the remote fax machine and once contact is made, scanning
and transmitting will proceed in real-time.
• With real time transmission, you can watch each page as it is scanned and sent.
To perform a real time transmission:
1
Set the document in the ADF.
NOTE:
The document glass cannot be used for real time transmission.
2
Press [FAX] to display the Fax standby mode.
3
Adjust the scanning resolution and contrast, if necessary. (See page 3-2.)
4
Press [Others], [Prev] or [Next], [Memory Tx], then press [Enter].
(When “All” tab is selected)
Now the memory transmission is set to [OFF].
NOTE: • You can assign [Memory Tx] to the soft key. See “Soft keys” on page 10-2.
• You can change the default setting for [Memory Tx]. See “Accessing the
default settings” on page 12-4.
5
Specify the destination.
• Use the numeric keys to dial the number.
– or –
• Specify the destination using the address book. (See page 2-12.)
Press [Reset] to cancel the settings.
NOTE:
With real time transmission, you can dial only one destination. When you select
multiple destinations, real time transmission will be disabled.
6
Press [Start].
• To cancel the transmission, use Review commands features, see “Chapter 6
Reviewing or canceling commands”.