Filter
Top Products
14-17MAINTENANCE & TROUBLESHOOTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
MAINTENANCE & TROUBLESHOOTING
AI
Message on the display Description / Solution
Cannot store in a secure
box.
You tried to store a document in an F-code Secure box. If you need to store documents,
use an F-code Bulletin box.
Cannot use the same
code for both Read/Write
and Read Only.
You cannot use the same protect code for “Read/Write” and “Read Only”. Enter a differ-
ent one.
Check Paper Source
The selected paper is not suitable for copying or printing. Select other paper source.
Check the paper size.
Open & Close Front
cover.
The loaded paper does not match the paper registered in the machine.
Set correct sized paper or change the paper size setting.
Open and close the front cover to reset the printer.
Close XXX Cover
The cover indicated on the display is open or has not been closed securely. Close it
properly.
Close XXX cassette
The paper cassette indicated on the LCD is open or has not been closed securely. Close
it properly.
Close the Scanner Unit
The scanner unit is open. Close the scanner unit.
Communication error
A communication error disrupted the reception or transmission. If you were trans-
mitting, press [Stop] to clear the error message and then re-try the transmission. If
you were receiving a fax, try to contact the other person and have him/her re-try the
transmission.
Communication in
progress.
The function is not available during communication. Wait until it ends.
Contact service for
printer option
An internal error has occurred. Contact your Muratec dealer.
Continue to store?
[Yes] [No]
The document has jammed while being stored into memory. To continue storing press
[Yes], to cancel the job press [No].
Copy protected
Copy is protected.
To copy, set [Copy protect] to [OFF].
During copy protection, Macro program is disabled.
Copy reservation has
been disabled.
Copy reservation is disable. Wait until the present job is completed.
Cover Open
Close XXX Cover
The cover indicated on the LCD is open or has not been closed securely. Close it prop
-
erly.
DHCP server did not
respond.
DHCP configuration failed. Check the network connection. If the LAN cable is not con-
nected, connect it to the machine to connect to the LAN.
If the DHCP server is not installed on your network, turn off the “DHCP setting” and
register the IP address manually.
For more information, refer to the “Network Guide”.
Dialing number has not
been set.
You are selecting a non-registered address book number. Check the address book num-
ber and try again.
Document full
You tried to store a document in a Batch Tx box, but the machine has reached its capac-
ity (40 documents). Delete unnecessary documents stored or use other Batch Tx box.
Document stored
You tried to erase a batch box which contains at least one document. To erase a batch
box, erase all the documents stored in the box.
Drum should be
replaced.
The drum cartridge has run out. Replace with a new drum cartridge.
Enter location.
No destinations are entered. Enter at least one destination to register the setting.
Enter the end day.
The end forwarding day is not entered in Fax forward setting.
Enter the end time.
The end forwarding time is not entered in Fax forward setting.
Enter the start day.
The start forwarding day is not entered in Fax forward setting.
Enter the start time.
The start forwarding time is not entered in Fax forward setting.