Filter
Top Products
MultiVOIP User Guide Quick Start Instructions
59
Phone/IP Starter Configuration
Full details here:
MVP2400
MVP2410x
MVP3010
Chapter 5: Technical Configuration for
Digital T1/E1 MultiVOIPs
in User Guide.
MVP130
MVP210x
MVP410x
MVP810x
Chapter 6: Technical Configuration for
Analog/BRI MultiVOIPs
in User Guide
1. Open MultiVOIP program: Start | MultiVOIP xxx | Configuration.
2. Go to Configuration | IP. Enter the IP parameters for your voip site.
3. Do you want to configure and operate the MultiVOIP unit using the web
browser GUI? (It has the same functionality as the local Windows GUI, but
offers remote access.)
If NO, skip to step 5.
If YES, continue with step 4.
4. Enable Web Browser GUI (Optional). To do configuration and operation
procedures using the web browser GUI, you must first enable it. To do so,
follow these steps. (The browser used must be Internet Explorer 6.0 or
above; or Netscape 6.0 or above.)
A. Be sure an IP address has been
assigned to the MultiVOIP unit
(this must be done in the
MultiVOIP Windows GUI).
E. Open web browser.
(Note: The PC being used must be
connected to and have an IP
address on the same IP network
that the voip is on.)
B. Save Setup in Windows GUI. F. Browse to IP address of
MultiVOIP unit.
C. Close the MultiVOIP Windows
GUI.
G. If username and password have
been established, enter them
when prompted by voip.
D. Install Java program from
MultiVOIP product CD.
(Must be Java Runtime Environment
1.4.0_01 or above.)
NOTE: Required on first use of
Web Browser GUI only.
H. Use web browser GUI to
configure or operate voip.
Need more
info?
See “Web Browser Interface” in Operation &
Maintenance chapter of User Guide (on CD).