Filter
Top Products
Technical Configuration (Analog/BRI) MultiVOIP User Guide
200
Write down the values for these IP parameters. You will need to enter these
values in the “IP Parameters” screen in the Configuration section of the
MultiVOIP software. You must have this IP information about every VOIP in
the system.
Analog Telephony Interface Parameters
(for MVP130/210/410/810)
The following parameters must be known about the PBX or telco central office
equipment to which the analog MultiVOIP will connect:
➼
Analog Phone Parameters
Ask phone company or
telecom manager.
Needed for:
MVP810
MVP410
MVP210
MVP130
Analog Telephony Interface Parameters:
Record for this VOIP Site
#
• Which interface type (or “signaling”) is used?
E&M_____ FXS/FXO_____
• If FXS, determine whether the line will be used for a
phone, fax, or KTS (key telephone system)
• If FXO, determine if line will be an analog PBX
extension or an analog line from a telco central office
• If E&M, determine these aspects of the E&M trunk
line from the PBX:
• What is its Type (1, 2, 3, 4, or 5)?
• Is it 2-wire or 4-wire?
• Is it Dial Tone or Wink?