Filter
Top Products
MultiVOIP User Guide Mechanical Installation
107
Cabling Procedure for MVP130
Power Connection
Network Connection
Ethernet
Command
Power
FXS/FXO
Command Port Connection
PBX
PSTN
Telephony Connection
FXS
FXO
Hub
Figure 3-14: Cabling for MVP130
Cabling involves connecting the MultiVOIP to your LAN and telephone equipment.
1.Connect the power cord supplied with your MultiVOIP to the power
connector on the back of the MultiVOIP and to a live AC outlet as shown in
Figure 3-14.
2. Connect the MultiVOIP to a PC by using a RJ-45 (male) to DB-9 (female)
cable. Plug the RJ-45 end of the cable into the Command port of the
MultiVOIP and the other end into the PC serial port. See Figure 3-14.
3. Connect a network cable to the ETHERNET 10/100 connector on the back
of the MultiVOIP. Connect the other end of the cable to your network.
4. If you are connecting a station device such as an analog telephone, a fax
machine, or a Key Telephone System (KTS) (FXS interface), or a PBX
extension (FXO interface) to your MultiVOIP, connect one end of an RJ-11
phone cord to the Channel 1 FXS/FXO connector on the back MultiVOIP
and the other end to the device or phone jack. You will define the interface
in the Interface dialog box in the software when you configure the unit.
Proceed to Chapter 4 to load the MultiVOIP software.