Filter
Top Products
Technical Configuration (Digital Voips) MultiVOIP User Guide
122
Local Configuration
This manual primarily describes local configuration with the Windows GUI.
After IP addresses have been set locally using the Windows GUI, however,
most aspects of configuration (logging functions are an exception) can be
handled through the web browser GUI, as well (see the Operation and
Maintenance chapter of this manual). In most aspects of configuration, the
Windows GUI and web-browser GUI differ only graphically, not functionally.
For information on SNMP remote configuration and management, see the
MultiVoipManager documentation.
Pre-Requisites
To complete the configuration of the
MultiVOIP unit, you must know several
things about the overall system.
Before configuring your MultiVOIP Gateway unit, you must know the values
for several IP and T1/E1 parameters that describe the IP network system and
telephony system (PBX or telco central office equipment) with which the
digital MultiVOIP will interact. If you plan to receive log reports on phone
traffic by email (SMTP), you must arrange to have an email address assigned
to the VOIP unit on the email server on your IP network.
IP Parameters
The following parameters must be known about the network (LAN, WAN,
Internet, etc.) to which the MultiVOIP will connect:
➼
Ask your computer network
administrator.
Info needed to operate:
all MultiVOIP models.
IP Network Parameters:
Record for each VOIP Site
in System
#
• IP Address
• IP Mask
• Gateway
• Domain Name Server (DNS) Info
(not implemented; for future use)