Filter
Top Products
Mechanical Installation MultiVOIP User Guide
104
5.Repeat the above step to connect the remaining ISDN telephone equipment
to each ISDN connector on your MultiVOIP. Be aware that you can assign
each ISDN line separately and independently to either Network mode or
Terminal mode. That is, all ISDN lines do not have to be assigned in to the
same operating mode.
6.Ensure that the unit is properly connected to earth ground by verifying that it
is reliably grounded when mounted within a rack.
This can be accomplished by connecting a grounding wire between the
chassis and a metallic object that will provide an electrical ground.
7.Turn on power to the MultiVOIP by placing the ON/OFF switch on the back
panel to the ON position. Wait for the Boot LED on the MultiVOIP to go off
before proceeding. This may take a few minutes.
Proceed to Chapter 4 to load the MultiVOIP software.