Filter
Top Products
MultiVOIP User Guide Overview
17
Supplementary Telephony Services. The H.450 standard (an addition to
H.323) brings to voip telephony more of the premium features found in PSTN
and PBX telephony. MultiVOIP units offer five of these H.450 features: Call
Transfer, Call Hold, Call Waiting, Call Name Identification (not the same as
Caller ID), and Call Forwarding. (The first four features are found in the
“Supplementary Services” window; the fifth, Call Forwarding, appears in the
Add/Edit Inbound phonebook screen.) Note that the first three features are
closely related. All of these H.450 features are supported for H.323 operation
only; they are not supported for SIP or SPP.
T1 Front Panel LEDs
The MVP2400, MVP2410, and MVP24-48 all use a common main circuit
board or motherboard. Consequently the LED indicators are the same for all.
Figure 1-2. MultiVOIP MVP2400 Front Panel
Active LEDs. The MVP2410 front panel has two sets of identical LEDs. In
the MVP2410 as shipped (that is, without an expansion card), the left-hand set
of LEDs is functional whereas the right-hand set is not.
When the MVP2410 has been upgraded with an MVP24-48 kit, the right-hand
set of LEDs will also become active.
Figure 1-3. MultiVOIP MVP2410x Chassis
T1 LED Descriptions
The descriptions below apply to all digital T1 MultiVOIP units. The
MVP2410 has four sets of LEDs plus a lone LED at its far right end. As
viewed from the front of the MVP2410, it is the two left groups that are active
and present feedback about the operation of the unit. If an MVP24-48
expansion card is added to the MVP2410, the two LED groups on the right
become operational with respect to the second T1 connection.