Filter
Top Products
MultiVOIP User Guide Quick Start Instructions
47
Introduction
This chapter gets the MultiVOIP up and running quickly. The details we’ve
skipped to make this brief can be found elsewhere in the manual (see Table of
Contents and Index).
MultiVOIP Startup Tasks
Task Summary
● Collecting Phone/IP
Details (vital!)
The MultiVOIP must be configured to
interface with your particular phone system
and IP network. To do so, certain details
must be known about those phone and IP
systems.
● Placement
Decide where you’ll mount the voip.
● Command/Control
Computer Setup:
Specs & Settings
Some modest minimum specifications must
be met. A COM port must be set up.
● Hookup Connect power, phone, and data cables per
diagram.
● Software Installation This is the configuration program.
It’s a standard Windows software
installation.
● Phone/IP Starter
Configuration
You will enter phone numbers and IP
addresses. You’ll use default parameter
values where possible to get the system
running quickly.
● Phonebook Starter
Configuration
The phonebook is where you specify how
calls will be routed. To get the system
running quickly, you’ll make phonebooks
for just two voip sites.
● Connectivity Test You’ll find out if your voip system can
carry phone calls between two sites. That
means you’re up and running!
● Troubleshooting Detect and remedy any problems that might
have prevented connectivity.