Chapter 3 ( SRS-1050 Local Features
Page 3-25
To disable the intercom feature,
dial 3 and press ENTER. When
the screen displays the message
INTERCOM TURNED OFF, press
REG (softkey 4) to return to
normal operation.
4. Dial a telephone number of up to
ten digits (including wild cards)
and press ENTER (softkey 1).
When you press ENTER, a
screen appears announcing
ONE (or TWO) WAY TURNED
ON and showing the number
you entered:
TWO WAY TURNED ON
985*3112
If a Call Screener has Directory
Numbers identified by three, four,
or five digit extension numbers,
you can dial either the extension
number only or the full number.
You can also dial an asterisk as a
wild card character. See the
section introduction for a
complete explanation of these
choices.
Three Call Screeners can be
entered. To program the second
or third number, see step 5.
5. Press (*), 11, ENTER, repeat
steps 2,3, and 4 as needed until
this screen appears:
INTERCOM FEATURE (1)
(ONE OR TWO WAY) 2345
6. Press NEXT (softkey 2) and this
screen appears:
INTERCOM FEATURE (2)
NONSUPPORTED
Follow steps starting at # 2 to
program the last two numbers.
7. Press REG (softkey 4) to return
to normal operation.
Announcing a Call by
Intercom
This procedure describes a
typical sequence for announcing
a call by intercom. The procedure
addresses the call screener since
the call recipient has little to do.
The only action possibly required
of the recipient is described in
step 3.
The procedure also assumes that
both the screener and the call
recipient have an SRS-1050 digital
set, although only the recipient
must have one. If the call
screener has some other
telephone set, the exact procedure
may be different.
This procedure is by no means
the only way that you can use
Call Announce Intercom, but it is
the simplest and fastest.