Fujitsu SRS-1050 Telephone User Manual


 
SRS-1050 Voice Features ( Chapter 2
Page 2-6
If you are already talking on
another call
1. Handle the active call in one of
the following ways:
a. End the call by pressing the
button in the handset cradle.
Then press the green-
flashing Call Appearance
button to answer the
incoming call.
or
b. Retain the call by pressing
the green-flashing Call
Appearance button to
answer the incoming call.
or
c. Press the green-flashing Call
Appearance button to
answer the incoming call.
This will either hang up on
the active call or
automatically place it on
hold, depending on your
installation. Your System
Administrator can tell you
which occurs.
2. Converse with the calling party.
3. When your conversation ends,
hang up by replacing the
handset in its cradle. Note the
displayed call duration; it
vanishes after about three
seconds.
4. You can pick up the call you
were originally talking on, or if it
was held, by pressing the
button next to its red-flashing
Call Appearance and picking up
the handset.
Placing Handsfree Calls
A handsfree call uses the
integrated microphone and
speaker instead of the handset.
The procedure below assumes
that the MIC-OFF (mute) key
feature is active. If not, the
microphone is always on.
If you are not talking on
another call
1. Press the SPEAKER button. Its
LED will light red (if not, press
an idle Call Appearance) and
you will hear a dial tone. (If this
connects you with a ringing call,
follow the procedure "If you are
already talking on another call".)
2. Dial the desired number by
pressing the keys on the
numeric keypad.
3. If your call is not answered, you
can use either of the following
methods to hang up:
a. Press SPEAKER.
continued