Filter
Top Products
SRS-1050 Local Features ( Chapter 3
Page 3-18
2. Press the multifunction button
you have chosen to be the
delimiter key and then press
ENTER.
The indicator for the button you
have chosen turns green and its
number appears on the display.
If you have previously assigned a
button as the delimiter key, its
indicator turns green when you
complete step 2. You have two
choices at this point:
• If you press a different
button and press ENTER, the
indicator of the previously
assigned button goes off and
the indicator of the new
button turns green. The
number of the new button
appears on the display.
• If you press the previously
assigned delimiter button and
press ENTER, you cancel the
button as the delimiter key.
Its indicator goes out.
After you assign (or cancel) a
button, the screen looks like this:
DELIMITER KEY = (17)
COMPLETED
If you have canceled a button, the
end of line 1 includes the word
CANCEL.
3. To complete the procedure,
press REG (softkey 4). The
standard display screen
reappears.
CALL ANNOUNCE INTERCOM
The Call Announce Intercom
feature is a convenient way for a
person screening incoming calls
to announce the call to the
intended recipient. The screener
places the incoming call on hold,
uses a designated Directory
Number to announce the call to
the recipient via intercom, and
may then transfer the call. The
screener can also use this feature
to deliver a message.
The Call Announce Intercom
operates in one of two modes,
two-way or one-way intercom.
Two-way intercom immediately
activates the speaker and
microphone of the called digital
set, allowing two-way
communication. One-way
intercom activates only the
speaker, leaving the microphone
of the recipient's digital set turned
off in the interest of privacy. The
recipient must press the MIC-OFF
button to respond to the call
screener.