Filter
Top Products
Chapter 3 ( SRS-1050 Local Features
Page 3-19
Call Announce Intercom allows
you to specify which call buttons
are activated by Call Announce
Intercom Call Screeners, and
allows you to select up to three
Call Screeners.
Ringer Always On
The Call Announce feature
utilizes a Ringer Always On mode.
Ringer Always On sends a tone
to users each time a Call Screener
activates Call Announce Intercom
(regardless of the ringer mode).
The Call Announce Intercom is
distinct from the network-based
intercom feature. Call Announce
Intercom activates automatically.
With the network-based intercom,
the recipient must answer the
intercom call. You could,
however, use the network-based
feature to simplify dialing for Call
Announce Intercom, allowing the
call screener to dial one or two
digits rather than the recipient's
full extension number. You could
also eliminate dialing entirely with
dedicated intercom, another
network-based feature.
Figure 3-1 shows a typical
application of Call Announce
Intercom.
Call Screeners Call Recipient
í
Directory Numbers Call Announce
Intercom setup:
3110 Activating
Directory
3111 Number = 3112
3112* Intercom mode =
1-way or 2-way
*Designated for intercom
Figure 3-1 Call Announce
Intercom Application
This section describes the
requirements for setting up Call
Announce Intercom followed by
the procedures to use Call
Announce Intercom to announce
a call.
Enabling or Disabling Call
Announce Intercom
To enable or disable call
announce intercom, follow these
steps:
1. Press REG (softkey 4), 11,
ENTER (softkey 1).