Filter
Top Products
Appendix A ( SRS-1050 Installation
Page A-5
CONNECTING TO THE
NETWORK
When you receive your SRS-
1050, plug the telephone line
from the wall into the LINE
socket on the back of the set.
If the display shows a date and
time, you have power. If the
display does not light up, you
may need a power supply to
connect to the wall socket and
to the 40 V DC power socket
on the back of the set.
If you are connecting power for
the first time, you should see
the message SPID NG. See
the next section to enter a
Service Profile Identifier (SPID).
ENTERING THE SPID
The Service Profile Identifier
identifies your set to the
network. You will need to enter
a SPID if you are on a
multipoint configuration.
Do not change your SPID
unless told to do so by your
service provider. In most
cases, digital sets will not work
without the correct SPID
number. If the SPID number is
wrong, the set displays the
message SPID NG. Enter the
correct SPID number, and then
disconnect and reconnect
power to make the set function
normally.
To enter the service profile
identifier, follow these steps:
1. Press REGISTER (softkey 4)
8, ENTER (softkey 1).
The message ENTER SPID
appears, with the current SPID
number (if any) shown below it.
ENTER SPID
ID=000000000000
2. Dial your SPID number and
press ENTER.
This screen appears:
SPID ASSIGNMENT END
ID=XXXXXXXXXX
3. Press REGISTER (softkey
4) to return to normal
operations.
PROGRAMMING AND
LABELING THE SET
Refer to Chapter 3 for
procedures to:
• Enable headset use and turn
off handsfree mode, if desired.
• Set operating parameters
such as ringer volume and
tone.
• Program the calendar/clock
and other local features.