SRS-1050 Local Features ( Chapter 3
Page 3-6
To change another setting, you
can press asterisk (*) to return to
the menu mode options.
Selecting Ringer Pattern
This selection determines the
type of ring that announces an
incoming call when you are
conversing on another line.
1. Press REG (softkey 4), 7, ENTER
(softkey 1). This screen
appears:
RINGER SERVICE MODE
. . . . . . . . . . . . . . . . . . . . . . . . . . .
2. Press ENTER again and this
menu appears:
1:VOLUME 2:TONE
3:RINGING (SELECT 1-4)
The selection you want appears
on the second screen of the
menu, which you can see by
pressing NEXT (softkey 2).
3. Press 4, ENTER. A screen
appears showing you the
current ringer pattern setting:
RINGER PATTERN MODE
MUTE RING
4. Press ENTER again and this
menu appears:
1:MUTE RING 2:ONE RING
(SELECT 1-2)
5. Select 1 for a mute ring, a normal
ring pattern at reduced volume,
or 2 for one ring, which rings
once at normal volume. Then
press ENTER. The screen
shows your selection plus the
word COMPLETED:
ONE RING
COMPLETED
6. To return to the normal display,
press REG (softkey 4).
To change another setting, you
can press asterisk (*) to return to
the menu mode options.
PROGRAMMING A BUTTON
FOR ONE-TOUCH DIALING
You can program up to 17 buttons
to play back numbers you enter
(up to 30 digits each). The
numbers you program can be any
of the following:
• Standard telephone numbers,
including the outside line
access code if required
• Special codes such as a
personal ID number or a voice
mail access code, or a network
access code