Fujitsu SRS-1050 Telephone User Manual


 
SRS-1050 Voice Features ( Chapter 2
Page 2-12
or
c. Press an idle Call
Appearance button, which
will normally give you a dial
tone.
4. If your call is answered,
converse with the called party.
5. When the conversation is over,
hang up by pressing SPEAKER.
Note the displayed call
duration; it vanishes after about
three seconds.
6. You can pick up the call you
were originally talking on, if it
was held, by pressing its red-
flashing Call Appearance
button.
Note: Onhook dialing. In place
of steps 1 and 2, you can dial
the number first and then
press SPEAKER. The phone
automatically dials the
number. The number you
enter remains available for
dialing for about three
minutes.
You can also use a one-touch
button after handling the
existing call. This
automatically selects an idle
CA and dials the number.
Skip step 2.
(See also "Handsfree, Handset,
and Headset Modes", in Chapter
3, "Local Features".)
Receiving Headset Calls
An incoming call makes the Call
Appearance's LED flash green.
If you are not talking on
another call
Place the headset on your head in
a position comfortable for hearing
and talking. If necessary, unplug
the handset from the jack on the
phone's left side. Plug the
headset into the same jack. Also
check that headset mode is
activated. (See Chapter 3 for
details.) The handset, speaker,
and microphone will be disabled.
All dialing tones and telephone
conversation will be audible only
through the headset. Your voice
and any other transmitted sounds
will go through the headset
microphone only.
1. Press the green-flashing Call
Appearance button. (In some
installations, pressing the
SPEAKER button will work
also.)
2. Converse with the calling party.
3. When your conversation ends,
hang up by pressing SPEAKER.
Note the displayed call
duration; it vanishes after about
three seconds.