Chapter 3 ( SRS-1050 Local Features
Page 3-13
Some of the data entry displays
have built-in timers. If you do not
enter information within fifteen
seconds, the display reverts to
the menu for selecting the feature
you were setting up. You must
reselect the feature and start
again.
If for any reason you become
confused, you can always press
REG (softkey 4) to return to the
menus and start over.
Enabling the UNA Feature
To enable unanswered call
logging and select the type of
UNA to be used, follow these
steps:
1. Press SERVICE, then REG
(softkey 4), 4, ENTER (softkey
1).
If the following screen appears,
the UNA feature is disabled:
UNA SERVICE MODE
NON SUPPORTED
To leave it as is, press REG again.
2. To enable UNA, press ENTER.
This screen appears:
1: ALL MODE 2: SELECT MODE
3: NO SUPPORT MODE SELECT ITEM
(1-3)
3. Press the number shown beside
the mode you want to select,
then press ENTER. The
following sections describe
each mode.
UNA on All Call Appearances
To support UNA on all Call
Appearances, follow these steps:
1. Press 1, ENTER, and this screen
appears:
SUPPORTED (ALL)
COMPLETED
After about 15 seconds, or if you
press asterisk (*), the display
returns to the second Service
Mode screen:
4: UNA 5: H-FREE
6: HAND/HEAD SELECT ITEM (1-12)
2. You can now select a different
menu function, or press REG
(softkey 4) to return to the
normal display:
UNA on Selected Call
Appearances
To support UNA on selected Call
Appearances, follow these steps:
1. Press REG, then ENTER (two
times).