Chapter 3 ( SRS-1050 Local Features
Page 3-17
4. Press ENTER. This screen
appears:
SUPPORTED
COMPLETED
You can now use the speaker.
The SPEAKER button can control
call pickup or hang-up if the
handset is in its cradle. The MIC-
OFF button (if active) controls the
microphone if the speaker is in
use. If MIC-OFF is pressed, key
tones can be heard, but no other
sounds are transmitted until MIC-
OFF is pressed again.
Switching Back to Handset-
only Operation
Do steps 1 through 4 (from the
previous section), but in steps 3,
press 2 instead of 1. The final
screen will look like this instead:
NON SUPPORTED
COMPLETED
When the display shows the
selection you prefer, press REG
(softkey 4) to return to the normal
display.
Assigning a Leased Network
Access Code Delimiter
Before you can dial a leased
network number, or program a
one-touch button to dial such a
number, you must assign one of
your multifunction button as a
leased network access code
delimiter key.
The procedure to dial a leased
network number is the last
procedure in the Placing and
Receiving Calls section of
Chapter 2.
The section Programming a
Button for One-touch Dialing
earlier in this chapter tells you
how to program a one-touch
button for a leased network
number.
To assign one of the
multifunction buttons as the
delimiter key for entering leased
network access codes, follow
these steps:
1. Press REG (softkey 4), 10,
ENTER (softkey 1). This screen
appears:
USER CODE MODE
SELECT ASSIGN KEY
The indicator of any one-touch
buttons you have assigned, and
the MIC-OFF key if activated,
turn red.