Fujitsu SRS-1050 Telephone User Manual


 
Chapter 3 ( SRS-1050 Local Features
Page 3-21
TWO WAY SELECTED
ENTER TELEPHONE NUMBER
4. Dial a telephone number of up to
ten digits (including wild cards)
and press ENTER (softkey 1).
If the call screener has Directory
Numbers identified by three-,
four-, or five-digit extension
numbers, you can dial either the
extension number only or the full
number. You can also dial an
asterisk as a wild card character.
See the section introduction for a
complete explanation of these
choices.
When you press ENTER, a screen
appears announcing ONE (or
TWO) WAY TURNED ON and
showing the number you entered.
TWO WAY TURNED ON
985*3112
5. Press REG (softkey 4) to return
to normal operations.
Call Announce Intercom on
Selected Buttons
Before selecting Directory
Numbers for call screeners, you
may specify the Call Appearance
buttons that are to be answered
automatically. You may select
"ALL" buttons or select the
desired Call Appearances.
To enable or disable Call
Announce Intercom on selected
buttons, follow these steps:
1. Press REG (softkey 4), 11,
ENTER (softkey 1). A screen
appears showing the current
status of the intercom feature:
INTERCOM FEATURE
SUPPORTED (ALL, SELECT,
NONSUPPORTED)
2. Press ENTER.
The Call Announce Intercom
button selection screen appears:
1: ALL MODE 2: SELECT
MODE
3: NO SUPPORT MODE SELECT ITEM (1-
3)
To make your choice, dial 1 or 2
and press ENTER. If you selected
2, the following screen appears:
SUPPORTED (SELECT)
SELECT ASSIGN KEY