Fujitsu SRS-1050 Telephone User Manual


 
Chapter 1 ( SRS-1050 Overview
Page 1-7
Call Handling Example with
Multifunction Buttons
Suppose your Directory Number
is 747-3456, and the first three
multifunction buttons on your
SRS-1050 have been assigned
that number.
What does it mean to have three
Call Appearance buttons
assigned to one Directory
Number? It means you can have
up to three calls at the same time
using that single Directory
Number, though you can talk on
only one at a time.
For example, if you have no calls
in progress and someone dials
747-3456, your telephone rings
and the LED for the first Call
Appearance button associated
with 747-3456 flashes green. You
can answer the call by pressing
that Call Appearance button and
picking up the handset. (The LED
turns steady red.)
After answering the call, you can
press the second 747-3456 Call
Appearance button to originate
another call. The first call is
automatically put on hold. If
another call comes in, you can
press the third Call Appearance
button representing 474-3456 to
answer the third call. The second
call is also placed on hold.
You would then have three calls
on your 747-3456 Directory
Number. Only then is your 3456
number "busy", that is, when all
three assigned Call Appearance
buttons are in use.
CALL INFORMATION
DISPLAYS and SOFTKEYS
1=747-3456 (Line 1)
12:55PM TUE MAY 5 (Line 2)
When you make a call, the
number you dialed, including any
prefix, appears on line 1 of the
display, along with an ISDN Call
Identifier (ICI) code if provided at
your installation. (See Appendix
C for a partial list of ICI codes.)
For an incoming call, the calling
party's number appears if the
network supplies the digital set
with the Calling Line ID (CLID).
When your party answers, the
end of line 2 shows call duration
timing as minutes and seconds in
the form mm:ss. This timer will
record for an hour, up to 59:59,
and then it restarts at 00:00. If the
call cannot go through, line 2
shows a message such as "Busy"
or "NOT ANSWERED".
Line 1
Line 2
SOFTKEYS AND KEY MENU