Filter
Top Products
SRS-1050 Line Parameters ( Appendix B
Page B-2
(If your ringing preference was
set to IDLE and there are no lines
available, the SRS-1050 does not
connect to a line until you press a
Call Appearance button.)
AUTOHOLD
The second choice, called
autohold, affects what happens
when you are on an active call on
one CA and then press another
CA. The active call you were on
can be dropped or held
automatically. If it is dropped, the
LED goes dark. If it is held, the
LED flashes red. Your phone will
consistently drop or hold your
active call when you press
another CA based on the
configuration choice recorded
with your telephone provider.
ONETOUCH
The third choice, called onetouch,
affects whether handsfree
operation is automatically
selected when you press an idle
CA, causing you to hear a dial
tone through the speaker. Your
phone will consistently remain in
handset mode or automatically
enter handsfree operation based
on the configuration choice
recorded with your telephone
service provider.
Guide Assumptions
To simplify presentations in this
guide, the text assumes that
handsfree operation is automatic
when you press an idle CA, that
is onetouch is "yes". If your
installation is different, then to
get dial tone after pressing an idle
CA, you must either press
SPEAKER for handsfree
operation or lift the handset.