Filter
Top Products
220
Card Identification (CARDID.EXE)
This client device driver detects the insertion and removal of PC cards, automatically determines the
card type upon insertion, and then configures the card and slot/adaptor (if it is an I/O Card).
SRAM Card Driver (MTSRAM.EXE)
This SystemSoft device driver recognizes and supports SRAM cards.
IDE/ATA Support (ATADRV.EXE)
ATADRV.EXE is a block device driver that supports ATA Type II Flash Disk or ATA Type III
hard disk PC cards.
Option
/S:x
Safe mode
Range: 0 to 8 (Default: 2)
Specifies if ATADRV is to be run in slave mode. The MTD Driver (MTDDRV) is the only master
control driver currently available. Installs the ATADRV device driver as a slave(/S:x) to MTDDRV.
It also specifies the number of devices (1 to 8) it can support. A value of 0 can also be used with /D
or /S. When a value of 0 is used, only the mode that was specified (/D or /S) is implemented, not the
number of devices assigned during installation or specified using the CONFIG utility. When this
/S switch is used, ATADRV must be installed in CONFIG.SYS before MTDDRV and both
ATADRV and MTDDRV must be installed before CARDID. Refer to ATA Driver Modes section
which follows.
Option
/D:x
Number of Drive units
Range: 0 to 8 (Default: 2)
Specifies the number of drives that the system supports when installed either as a block device driver
or as a slave device driver. Installs the ATADRV device driver as a block device driver (/D:x).
It also specifies the number of drives (1 to 8) it can support. A value of 0 can also be used with /D or
/S. When a value of 0 is used, only the mode that was specified (/D or /S) is implemented, not the
number of drives assigned during installation or specified using the CONFIG utility. When the /D
switch is used, ATADRV must be installed in CONFIG.SYS before utility. When the /D switch is
used, ATADRV must be installed in CONFIG.SYS before CARDID.