Filter
Top Products
185
Setting Operation Mode / DT-9656BCR
Overview
On the OBR various settings, as listed below, can be made through command transmission.
(For a list of actual commands refer to the Command List.)
1. Readability of code
2. Adding a readable code
3. Data transfer SYNTAX
4. Condition for the least significant digits
5. Specifying the buzzer activation mode
6. Specifying the LED ON mode
7. Read mode
8. Read time
9. Mark/base of barcode
10. Redundant read
11. Use of Length CODE
12. Specifying write to EEPROM
Transmission of Command
Commands must be transmitted using the OBR-Send function.
Example: To specify "Read all codes"
OBR_Send ("A0");
Writing Set Values to EEPROM
The OBR is provided with a function to write the current setting values to EEPROM. To do this,
transmit the 'Z2' command.
If this is not done, other commands that have been transmitted previously to the 'Z2' command will
not be written to EEPROM. As a result, they will be lost when the power is turned off and the
settings specified by these commands will not be valid the next time the power is turned on.
Example: To specify "Read all codes" and write to EEPROM
OBR_Send ("A0");
OBR_Send ("Z2");