Filter
Top Products
Avaya Application Solutions
28 Avaya Application Solutions IP Telephony Deployment Guide
i120 constructs
Each i120 construct contains the following ports:
● One analog trunk port
● Two analog line ports
● One Contact Closure Adjunct (CCA) port
● One Ethernet WAN port (not used with Distributed Office)
● One Ethernet LAN PoE port
● One console cable port
● One interface USB port (located on the chassis where you connect the Disk on Key)
● One USB port (for use with a USB modem for servicing the platform)
● One Ethernet services port
Note:
Note: If you need additional ports, additional Media Modules are available for the i120
platform constructs. See your Avaya representative for details.
In addition to these ports, the i120 contains additional ports based on its construct. Table 2
shows the ten i120 constructs, and a description of what additional ports are available for each.
The legend for the various construct names is a follows:
Legend:
A = Analog (RJ-11, 2-wire)
B = BRI
D = Digital (DS1, T1, E1, and PRI)
H = High Capacity (24 analog ports using a single connector)
P = Power over Ethernet (PoE)